Is Connector - tee type "Y" BURGACLIP, 548752 compatible with hose type 3090 and standard automotive A/C pressure ranges?

Yes. Connector - tee type "Y" BURGACLIP, 548752 is designed specifically for hose type 3090 for air conditioning and is made of steel, so it is compatible with hose type 3090. Steel construction provides the strength and corrosion resistance needed for typical automotive A/C systems. Regarding standard automotive A/C pressure ranges (low side ~0â50 psi, high side up to ~400â450 psi depending on system and operating conditions), a correctly sized steel tee for hose 3090 is suitable to handle those pressures when properly installed and secured with the appropriate clamps or fittings. Ensure installation follows manufacturer torque and sealing recommendations and that the specific application does not require additional pressure- or refrigerant-specific certifications.

Does Connector - tee type "Y" BURGACLIP, 548752 withstand refrigerant oil and common A/C lubricant compatibility with hose type 3090?

Connector - tee type "Y" BURGACLIP, 548752: Made of steel and designed for hose type 3090 for air conditioning. Steel construction offers good general resistance to refrigerant oils and common A/C lubricants used with typical refrigerants (Râ134a, Râ1234yf, Râ404A, etc.), so compatibility is likely when used with standard mineral, POE or PAG oils found in automotive and HVAC systems. However, longâterm compatibility depends on specific oil chemistry, concentration, temperature and seals used in the assembly. For guaranteed compatibility and warranty use, verify with the hose manufacturer and lubricant supplier or consult material compatibility data for the exact oil type and service conditions.

Can Connector - tee type "Y" BURGACLIP, 548752 be used with hose type 3090 in high-vibration vehicle A/C systems?

Yes. Connector - tee type "Y" BURGACLIP, 548752 can be used with hose type 3090 in high-vibration vehicle A/C systems, with some important caveats. Why itâs compatible - The part is specifically described as a "Y" type tee for hose type 3090 for air conditioning, so it is designed to mate with that hose profile and serve A/C refrigerant lines. - It is made of steel, giving it the mechanical strength and fatigue resistance generally required in high-vibration automotive environments. Conditions and recommendations - Proper installation: Correct hose seating, full engagement depth, and the manufacturer-recommended clamp torque or crimp procedure must be followed to prevent leaks or loosening under vibration. - Use the specified hose 3090 only: The connector is made for hose type 3090; substituting a different hose could compromise fit and sealing. - Vibration mitigation: Where vibration is severe, augment with vibration-damping supports, proper routing, and strain relief to minimize cyclic loads on the joint. - Inspection and maintenance: Regular inspection for signs of loosening, corrosion, chafing, or refrigerant leakage is advised, especially after the vehicle is put into service. - Compatibility check: Verify compatibility with the specific refrigerant, pressure rating, and temperature range of your A/C system to ensure materials and seals (if any) are appropriate. - Corrosion protection: Steel components in automotive A/C should be protected against corrosion (coatings, anodizing, or compatible blanks) where exposure to road salts or moisture is expected. Conclusion Connector - tee type "Y" BURGACLIP, 548752 is suitable for use with hose type 3090 in high-vibration vehicle A/C systems when installed per manufacturer guidelines, used with the correct hose/refrigerant, and combined with proper routing, support, and maintenance to mitigate vibration and corrosion risks.

Raccordo a T tipo “Y” BURGACLIP, 548752

Tubi e raccordi per condizionamento, Tutti i prodotti/

Additional information

Materiale	CS – acciaio (ghisa)

Raccordo a T tipo “Y” BURGACLIP per tubo tipo 3090 per aria condizionata. Materiale: acciaio.

Elenco delle varianti di prodotto

Codice articolo	Nome variante prodotto	DN	BAR	Disponibilità	Prezzo	Quantità	Azioni	Catalogo
BU-548752-08-08-08-S	Raccordo a Y per tubi 13/32", acciaio	-	35	In stock	0 zł		Richiesta

Hai bisogno di una quantità maggiore di prodotti o di un'offerta personalizzata?

Chiamaci: +39 348 811 3340 o scrivici: m.ceriani@tubes-international.com

INVIA RICHIESTA

Raccordo a T tipo “Y” BURGACLIP per tubo tipo 3090 per aria condizionata. Materiale: acciaio.

Additional information

Materiale	CS – acciaio (ghisa)

Hai bisogno di una quantità maggiore di prodotti o di un'offerta personalizzata?

Chiamaci: +39 348 811 3340 o scrivici: m.ceriani@tubes-international.com

INVIA RICHIESTA

Rete di vendita
Verifica

Richiesta
Invia

Prodotti correlati

Potrtai nelbuje per un'offerta disponibile per questo prodotto opure non elineato?

Chiamaci: +39 348 811 3340 o scrivici: m.ceriani@tubes-international.com

INVIA RICHIESTA

TUBI E RACCORDI PER L'INDUSTRIA

Raccordo a T tipo “Y” BURGACLIP, 548752

Additional information

Elenco delle varianti di prodotto

Hai bisogno di una quantità maggiore di prodotti o di un'offerta personalizzata?

Additional information

Hai bisogno di una quantità maggiore di prodotti o di un'offerta personalizzata?

Prodotti correlati

Ghiere per terminali tipo FR103 e FR104, ottone

Raccordo BURGACLIP 45° con filettatura interna UNF ORFS, acciaio, tipo 54502

Raccordo a 90° con boccola, ottone, tipo FR102

Potrtai nelbuje per un'offerta disponibile per questo prodotto opure non elineato?

Prodotti

Servizi

Contatti

Social Media

Trova il tubo o raccordo perfetto per il tuo impianto

Trova il tubo o raccordo perfetto per il tuo impianto

oppure clicca per vedere tutti i nostri prodotti

Scopri anche i prodotti più richiesti, già testati sul campo